Not at all. If you can screw in a shower head, you can install the water-side hardware. The system connects to your home WiFi automatically — just scan a QR code on your phone and you're done. No wiring, no programming, no plumber needed.

The Android app is available now. iOS is coming soon. In the meantime, any phone can use the browser-based controls by visiting your Trickle's local address on your home WiFi.

Yes — Trickle fits inline with virtually any standard shower setup in North America. It installs between your existing water supply and shower head using standard ½" connections. No special shower required.

Trickle runs entirely on your local home network — it doesn't need the internet to work. As long as your phone and the Trickle device are on the same WiFi, everything works normally. Your shower isn't going anywhere.

The electronics are housed in a sealed enclosure mounted outside the wet zone — typically on the wall near the shower, not inside it. The only parts that touch water are the valves, which are purpose-built for plumbing and fully rated for continuous water contact.

Trickle's efficient nozzle insert targets 1.5 GPM versus the standard 2.5 GPM — that's up to 40% less water per shower. Combined with the automatic shutoff and warm-up notifications that stop you running the water while you wait, real-world savings can be significantly higher.

Trickle is currently in home prototype and early-adopter phase. We're shipping to first customers soon. Leave your email in the Contact section below to get on the list.

Trickle was built by Tyler Becker — reach out directly at tbeckerr72@proton.me. Tyler built Trickle from the ground up — hardware, software, and app — and is actively looking for early adopters, hotel partners, and collaborators.